In Sink Erator Model 75 Driver And Hammer

If replacing a garbage disposal, click here for instructions.

This is not necessary in new construction.).

When both connections are free, remove the parts.

Clean off the old plumbers putty that surrounds the edge of the drain opening.

Drop the new sink flange into the drain opening and press it into place.

Placing a weight, such as your garbage disposal, on top of the sink flange will help hold the sink flange in place while mounting it to the sink.

To avoid scratching your sink or the flange, place a towel between the sink surface and the weight.

Tighten the three mounting screws, alternately tightening each screw a few turns at a time until the mounting assembly is evenly and tightly seated against the bottom of the sink.

In Sink Erator Model 75 Driver And Hammer

Lay the garbage disposal on its side and use a screwdriver and hammer to tap it out.

Next, remove the loose knockout plug from inside the garbage disposal.

Pull out wires. Insert cable connector (not included) and run electrical cable through access hole on bottom of garbage disposal.

Push wires into garbage disposal (do not displace cardboard shield) and replace electrical cover plate.

Holding the garbage disposal in place, turn the lower mounting ring until all three tabs are locked into the mounting assembly.

If the discharge tube is too long, cut off as much of the tube as necessary.

If you are connecting the garbage disposal to a dishwasher, it may be connected through an air gap.

Use a hose clamp to attach the drain hose to the dishwasher inlet.

Insert the Quiet Collar Sink Baffle into the sink opening by pressing it into the sink until it snaps into place.

Finally, turn on the electrical breaker to test its operation.

In Sink Erator Model 75 Manual